Senba Sensing초전기 적외선 감지에 초점19년 이상의 전문 제조 PIR 센서
Senba Sensing초전기 적외선 감지에 초점19년 이상의 전문 제조 PIR 센서
PROD Model: NS612
Window Size: 3*4mm
Output Signal:High and low level output
Sensing Distance: 10M (lens SB-F-02)
See lens selection for different distances
Sensing Angle: 120° (horizontal direction)
Working Voltage: 2.2-3.7V
Static Power Consumption: <11uA
NS612 is a type of PIR sensor which
integrates a digital control circuit and a human detection sensor in an
electromagenetic shielding housing.The human body detection sensor
couples the sensed human movement signal to the digital intelligent
integrated circuit chip through a very high impedance differential input
circuit, and the digital intelligent integrated circuit converts the
signal into an ADC digital signal.When the PIR signal exceeds the
selected digital threshold, there is a timed REL level output. OEN
enable terminal enables REL output or automatic control through light
sensor. Sensitivity and time parameters are set through a partial
voltage resistor. All the signal processing is done on the chip.
Digital signal processing
High power supply rejection ratio, anti-radio frequency interference(mobile phone,WiFi,etc.)
A second-order Butterworth bandpass filter with built-in infrared sensor to shield input interference at other frequencies
Sensitivity,Ontime, and light sensor Schmitt REL output.
Ontime adjustable
Good stability and effective suppression of repeated malfunctions
Low power consumption and simple application circuit
1.Absolute Maximum Ratings
Electrical characteristics(beyond those listed below may cause permanent damage to the device. Exposure to absolute maximum ratings may affect the device reliability. )
Parameter | Symbol | Min | Max | Unit | Remarks |
Operating Temp | TST | -30 | 70 | ℃ | |
Current into any pin | Into | -100 | 100 | mA | |
Storage Temp | TST | -40 | 80 | ℃ |
2. Operating Conditions (T=25°C, Vdd=3V，unless stated otherwise)
Parameter | Symbol | Min | Type | Max | Unit | Remarks |
Regular voltage | VDD | 2.2 | 3 | 3.7 | V | |
Supply current | IDD | 9 | 9.5 | 11 | μA | |
Sensitivity threshold | VSENS | 90 | 2000 | μV | ||
Detective Wavelength | λ | 5 | 14 | um | ||
Outputs REL | ||||||
Output current low | IOL | 10 | mA | VOL<1V | ||
Output current high | IOH | -10 | mA | VOH>(VDD-1V) | ||
Low REL output locking time | TOL | 2 | s | Non-adjustable | ||
High REL output delay time | TOH | 2 | 3600 | s | ||
Inputs SENS, ONTIME | ||||||
Input voltage range | 0 | VDD1/2 | V | Adjustable between 0V and VDD/2 | ||
Input leakage current | -1 | 1 | μA | |||
Input OEN | ||||||
Input low voltage | VIL | 0.8V-1.2V (Hysteresis zone) | 0.8 | V | Voltage threshold from high to low | |
Input high voltage | VIH | 1.2 | V | Voltage threshold from low to high | ||
Input current | II | -1 | 1 | μA | VSS<VIN<VDD | |
Oscillator and Filter | ||||||